Flag Honeywell Customer Service Review

Please use the form below to report a comment to us. We do our best to monitor user customer service reviews and we have zero tolerance for profanity, personal attacks and other malicious posts.

Thank you for taking the time to bring this review to our attention.

Everyone was polite and helpful, but having been in the military and captain of private vessals out at sea there is a need to know about the "elements" of the thing and not just how it works. Example: the "sending unit" part of the high and low settings on the R8182H are enacted as a direct result of the pickup coil or bellows of the sensor.. yes? thus it is possible to use it to turn things on and off which inits present configuration the lower range setting is designed to open the circuit to the pump and turn on the furnace to get more heat to maintain the temp for the hot water for showers. Makes sense, be sure princess does not scream as the water gets cold in her shower.
But, no longer using the unit a a hot water heater one only needs to have heat for the radiators. IN the same manner that AC units fan will stay on for a few minutes to draw outthe residual cold on the coils I too want to keep the pump on until the residual heat is drawn out of the boiler adn then when drops below preset temp it turns off. In colder areas they just keep the pump on all the time to keep pipes from freezing. So what it is the problem? there mist be a simple reversing of wires or resistors or something that will cause the switch to be closed when above a certain temp. and off when below a certain temp. Instead of going out and mounting a new separate thermostat in the furnace to do what I suggest it must be easier to simply use the lower range setting switch and change a wire or two to cause it to be used in reverse (on when hot and off when cold instead of what it is now, on when too cold and off once reaches desired temp.No drawings or schematic shows enough detail about the on off of this switch or how the bellows or electromagnetic pick up are and work so I can tap easily into the circuitry and reverse its workings and accomplish what I want to accomplish.
So now I must restudy and find electronics people who can maybe look at the schematic and tell me to cut, splice, remove, switch in order to work the way I want... gotta go ..Colin yeates


While You're Here...
  • Add new companies
  • Update listing information
  • Rate a company
  • Leave your comments
  • Link a YouTube video